If the electronics on the cartridges have failed, unfortunately this process will not work. If the printer thinks that both cartridges are empty, you will receive a second error message, and you will need to hold the button for another five seconds. The printer should continue printing, and use any of the remaining ink in the cartridge. You can override the empty cartridge message by holding down the “stop / reset” button on the printer for around five seconds. If you refill your cartridge, the printer will always show an empty cartridge message. It is not possible to reset the ink levels to full. The copper contacts on the outside of the cartridge contain the ink level information. The printer cannot physically see inside the cartridges to find out how much ink is left. Canon MG3120 - Reset Ink Levels on the Cartridges If it is the logic board, it is cheaper to replace the printer than to repair it. This can be checked by installing some old cartridges to see if the error clears. Most cases are due to the cartridge, and can be rectified by replacing the faulty cartridge. This error is shown when there is a faulty cartridge or a problem with the logic board in the printer. Canon MG3120 - Error P08 / Error P10 / Error 5200 / Error B200 #PIXAM 3120 FULL#The ink absorber is full and so there is a small chance of the printer leaking when it is moved! To be on the safe side, put it in a large bag first. Be careful when moving and disposing of the printer though. This means that the printer is at the end of it's life. The absorber can be can be cleaned, emptied and reset but it is an extremely difficult and messy process. That ink runs in to the waste ink absorber. Every time the printer runs a head cleaning routine, it flushes some ink through the print heads to keep them clean and clear. This error is shown when the waste ink absorber is full in the printer. Youtube video: Fix error P03 Canon MG3120 - Error P07 / Error 5B00 / Error E08 You may be able to fix it yourself if you are willing to take the machine apart and spend some time with it. Be extremely careful when touching this, as it is very delicate. The encoder film strip in the clear strip of plastic that the printer carriage runs on. The encoder film strip may have some dirty marks on it, and therefore needs cleaning. There may be a paper jam, check the printer thoroughly for any small pieces still stuck inside. One or both of the cartridges may have failed electrically, and need to be replaced. It could be that one or both of the cartridges are not inserted into the printer correctly. The Canon MG3120 can display this error for a few reasons. Change each cartridge in sequence until the error clears, this should help you identify which cartridge is causing the problem. Having some old cartridges around can be handy in this case. Remove both cartridges and then insert them again. This error is shown when there is a fault with one of the cartridges. It is quite easy to put an object on top of the printer only for it to fall in to the printer accidentally. It may not be paper that is causing the jam. Have a really good look inside to see what is still stuck. Small pieces of paper can get caught inside the printer mechanism if you had to rip the paper out of the machine. This error is normally the result of a paper jam.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |